SSD is soldered to the board. With only 8GB you’ll be using the swap partiton a lot so for anything exceeding 8GB of RAM you will be using the SSD as a slower “RAM” which will wear it’s lifespan down by constantly writing/reading into it’ s swap partition.
As far as I know Vivaldi is quite prepared to get things working as much as possible with Manifest V3 and putting a lot of work in their own adblocker as well because of it.
There is a version of UBlock Origin that works with V3 but it is limited compared to normal one, will see how it goes but for now I think they can delay with the V3 update for some time.
I personally don’t have a use for a mail client so majority of this update is useless to me but there are few interesting features I may get used to especially on my laptop.
I couldn’t care less about memory usage on my desktop with 64GB RAM but on my laptop that’s a different story. The Break Mode sounds also stupid at first but I may actually have use for it, will try and see.
Is there a way for KDE connect to connect PC with phone if phone is on WiFi and PC on LAN going trough different router in the same network?
Not just about “who owns it?” but also how does it work with insurance if something goes terribly wrong and who will bear the responsibility?
AI news barely able to make Onion obsolete, what a time to be alive!
Haven’t had any issues since I’ve installed it… Yet.
Well… fuck
deleted by creator
I did try and I like it a lot but I don’t want to daily drive testing build.
Wasn’t aware of the flatpack script, will check it out, thx!
Yeah, I’m aware it has different packages but I need to familiarise myself with docker first either way. Eventually I plan to switch both systems to PopOS Cosmic DE 24.04 once it fully releases so for now I’m spending most time just tinkering and trying to get more familiar with Linux. Pretty much all SW I use runs on it anyways too. Right now I want to get DavinciResolve up and running with my GPU.
If it breaks, it breaks… But I’ll give it a try on my laptop with PopOS
Thanks, I’ll look more into it once I get more time but from a glance this seems a bit too convoluted for my needs.
Does docker require virtualisation to be enabled?
It could but no
Why? Also I didn’t know about any docker container and never seen any mention of it when looking up solutions.
I just got it to work, I’ll update the original post with solution.
edit:
now I need to figure out if I can this up and running https://github.com/vosen/ZLUDA as it seems quite a bit interesting for both of our use cases though I’m fine with ROCm for the meantime, got 3x faster render speed vs just using my CPU
I’m quite certain it’s supposed to be working with 6000 series and up… I’ve even seen people run it on 5000 series RDNA cards in Blender like 1.5y ago on Fedora 37.
edit:
https://www.phoronix.com/review/blender-32-gpus
Officially, Blender 3.2 works with RDNA2 and RDNA(1) graphics cards on Linux with HIP. I was able to test all of my available Radeon RX 6000 (RDNA2) graphics cards with Blender 3.2, yeah! But with all my RDNA1 tested graphics cards they all yielded Blender 3.2 having a segmentation fault.
Yes. And instead of taking advantage of that they shrunk the battery to have thinner tablet instead of better battery life.
Have you tried Fedora recently or are you stuck in its early Wayland days?